Assembly Instructions

Disclaimer:

Always follow manufacturer’s safety instructions. Anyone working with any of the tools mentioned in this article must always use all safe practices, including but not limited to eye protection, skin protection, proper ventilation, and respiratory protection. Failure to take proper precautions is the responsibility of the individual in all cases.

Resin is a potentially hazardous material. Please take every precaution to avoid breathing in any resin dust created in filing, sanding or cutting any resin model. If you do inhale resin dust, contact your doctor immediately.

Acetone is potentially hazardous material. Please take every precaution to avoid breathing vapors and skin contact. Only use in well ventilated areas. Acetone is very flammable and should be handled with extreme caution. Always follow manufactures safety procedures.

Modeling glue is potentially hazardous. Please take every precaution to avoid breathing vapors and skin contact. I always follow manufactures safety procedures.

Cleaning agents are potentially hazardous, read, understand and follow all manufacturers instructions prior to using any product to clan models.

Xmarx takes no responsibility for any damages by any party with regards to our products or these instructions. Proceed at your own risk.

These models are not  toys and are not suitable for children under 18 years of age.

General Instructions:


Many of Xmarx models require assembly. If you need specific instructions on one of the models, please email.


Generally, there are only a few things to remember. First, clean your new model well. Either clean it with Acetone (see painting instructions) or use a 100 grit or higher sand paper and lightly sand the faces that will be glued together. This will assure a good fit as well as make sure that there is no mold release left on the piece to interfere with the glue bond.


Be sure to cut or sand off any flash left behind from the casting process.


From there, all you need to do is apply a thin layer of glue and stick them together.


Some pieces may require pinning. Drill a small hole in each piece, cut a length of paperclip and insert into one of the pieces, allow to dry. Cut to length for the other side and glue together.


Pinning is recommended for any of the larger pieces.


Mech Hanger Assembly Instructions